Alliance Laundry Systems LTZ87A*H0902 Series, Installation Instructions Manual

Page: 22 / 70

Installation
800941
20 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Electrical Requirements
Stacked Washers and Electric Dryers
(120/240 Volt, 60 Hertz, 3-Wire and Ground
Installation)
(120/208 Volt, 60 Hertz, 3-Wire and Ground
Installation)
NOTE: The wiring diagram is located behind the
control panel, inside the control cabinet.
Grounding and Wiring Instructions
NOTE: Single electrical connection serves both
washer and dryer.
The electric service must be a separate branch,
polarized, three-wire and ground, 120/240 Volt, or
120/208 Volt, 60 Hertz, AC single phase circuit fused
with 40 Ampere fuses.
The cord (supplied with dryer) and plug assembly
(obtain locally) should be plugged into an approved
receptacle that is mounted on the wall adjacent to the
unit. This receptacle should be accessible to the user or
service person when the unit is in position, to permit
disconnecting when necessary.
If the branch circuit to the dryer unit is 4.57 m (15 ft.)
or less in length, use U.L. (Underwriters Laboratories)
listed No. 10 A.W.G. wire (copper wire only) or as
required by local codes. If over 4.57 m (15 ft.), use
U.L. (Underwriters Laboratories) listed No. 8 A.W.G.
wire (copper wire only), or as required by local codes.
Figure 21
To reduce the risk of fire, electrical shock or
personal injury, all wiring and grounding
MUST conform with the latest edition of the
Canadian Electrical Code, Parts I and II, and
such local regulations as might apply. It is
the customer’s responsibility to have the
wiring and fuses checked by a qualified
electrician to make sure the laundry room
has adequate electrical power to operate the
unit.
W330
WARNING
D373I
1 Power Cord (Four-Wire)
1