Alliance Laundry Systems LEB07A*-1709, Service Manual, Page: 2 / 75

505033
1
© Copyright 1999, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without
the expressed written consent of the publisher.
Table of Contents
Section 1 – Safety Information .........................3
Section 2 – Introduction ....................................5
Nameplate Location .................................................5
Model Identification.................................................5
How Your Dryer Works...........................................6
Section 3 – Troubleshooting..............................7
1. Motor Does Not Run .........................................7
2. Unit Stops In Cycle; Quits After The First Few
Loads; Has A Burning Smell;
Cycles On Motor Thermal Protector .................8
3. Motor Runs But Cylinder Does Not Turn ........9
4. Motor Does Not Stop ........................................9
5. Heating Assembly Does Not Heat Or Burner
Does Not Ignite ...............................................10
6. Igniter Does Not Glow (Gas Supply Sufficient)
(Gas Models)....................................................11
7. Burner Ignites And Goes Out
Repeatedly (Gas Models).................................11
8. Igniter Glows But Burner Does
Not Ignite (Gas Models) ..................................11
9. Heater Assembly Or Burner
Shuts Off Prematurely......................................12
10. Heater Assembly Or Burner Repeatedly Cycles
Off On Limit Thermostat .................................12
11. Heater Assembly Or Burner
Does Not Shut Off ...........................................13
12. Clothes Do Not Dry .........................................13
13. Timer Does Not Advance In Automatic Cycle14
14. Clothes Are Too Hot When
Removed From Dryer ......................................15
15. Ignition Control Flashes ..................................15
Section 4 – Grounding .....................................17
16. Ground Wires From Terminal Block To Rear
Bulkhead And From Rear Bulkhead To Cabinet
Top And Control Panel. ...................................17
17. Ground Wires From Rear Bulkhead To Cabinet
Top And Control Panel. ...................................17
18. Ground Wires From Dryer Base To Wire
Harness And To Ignition Control (Gas Models
With Silicon Nitrate Ignition System). ............18
Section 5 – Service Procedures .......................19
19. Control Hood Assembly ..................................19
20. Control Hood End Caps...................................19
21. Graphic Panel...................................................20
22. Timer ...............................................................20
23. Fabric Selector Switch .....................................20
24. Signal ...............................................................20
25. Access Panel ....................................................22
26. Lint Filter .........................................................23
27. Loading Door And Door Hinge.......................23
28. Inner And Outer Door Panels And Door Pull..25
29. Door Strike ......................................................27
30. Door Seal .........................................................27
31. Front Panel And Panel Seal .............................28
32. Door Switch .....................................................28
33. Door Catch.......................................................28
34. Door Hinge ......................................................30
35. Hold-down Clips And Locators.......................30
36. Burner System Components (Gas Models) .....30
37. Burner Housing And Heat Shroud
(Gas Models)....................................................34
38. Limit Thermostat (Gas Models) ......................35
39. Heating Element (Electric Models) .................35
40. Thermostat And Heater....................................35
41. Air Duct ...........................................................36
42. Motor And Exhaust Assembly ........................37
43. Cabinet Top .....................................................40
44. Front Bulkhead Assembly ...............................41
45. Cylinder Belt....................................................43
46. Cylinder Assembly ..........................................44
47. Cylinder Rollers...............................................46
48. Outlet Cover ....................................................46
49. Rear Bulkhead And Heater Box ......................47
50. Terminal Block Or Power Cord.......................49
51. Cabinet.............................................................51
52. Base .................................................................53
Section 6 – Adjustments ..................................55
53. Leveling Legs ..................................................55
54. Burner Flame (Gas Models) ............................56