Diagnosing Failure 32
1. Check if the correct ma-
chine type is selected in the
Configuration Menu.
If the wrong machine type is
selected, enter the right ma-
chine type.
2. Check if the door is closed
and locked.
If the door is not closed,
close the door.
If the door is not locked, re-
pair the door lock system.
3. Check if the inverter is ener-
gized.
If the inverter is not energized,
check the power to the inver-
ter. Refer to
4. Write the parameters once
more into the inverter.
If the fault is persistent, con-
tact the manufacturer.
Table 76
Failure 35: Wrong Software Version
When a totally new software that isn’t backward compatible with
previous software versions is loaded, then the software will detect
that the old and new software's are not compatible. You have to
reconfigure the Wash Computer. Refer to
.
WARNING
All the custom settings will be erased in the wash
computer by loading the factory settings.
C080
After reconfiguration of the Wash Computer, fault 35 can only be
erased by switching the power Off/On.
Failure 36: The Linen is Not Correctly Distributed
in the Stage Before the Start Up of the Spinning
Sequence
This error occurs when the linen is incorrectly distributed in the
washer during the distribution stage (before the transition from
distribution revolutions into high revolutions).
In case that the unbalance detection system is activated, the ma-
chine attempts to redistribute the linen better. If there still is un-
balance in the machine, it lowers the revolutions of the spinning
sequence based on the unbalance magnitude. This function pre-
vents machine overload by uneven distribution of the filled-in
linen and thus increases the service life of the machine.
Diagnosing Failure 36
1. Unbalance may be caused
by inserting only half the linen
load into the machine.
Always fill in the machine
with a full load of linen. Do
not insert any other materials
than textile materials (fabrics).
Table 77
Failure 37: Drain Failure at the Spray Sequence
Failure 37 occurs when the electronic timer detects that the water
is not drained after 3 minutes at the Spray Sequence.
Diagnosing Failure 37
1. Check the drain tube of the
washing machine.
If the drain tube is blocked: re-
pair the drain tube.
2. Check the drain valve.
If the drain valve is defective:
replace the drain valve.
3. Check the wiring:
When the drain valve is
switched Off, the drain valve
should be open. (normal
open)
If the wiring is damaged: re-
pair the wiring.
Table 78
Failure 39: Empty Soap Supply Box
Failure 39 occurs when the electronic timer detects that the Soap
Reservoir is empty.
To avoid that No Liquid Soap is added at the wash process, the
operator gets a warning when a Liquid Soap Supply Reservoir is
almost empty.
Diagnosing Failure 39
1. Check if the Liquid Soap
Supply is empty.
Add Soap to the Liquid Soap
Supply System.
Table 79
Failure 41: Service Due Warning
Failure 41 occurs when the cycle counter of the Electronic timer
has reached the Programmed Value for Service due. The fault
message will be erased by opening the door. If the cycle counter
has not been reset the message will appear again at the end of the
next wash cycle.
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
96
Part No. D1631ENR7
Summary of Contents for IYG065J
Page 2: ......
