512261
25
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
26. FABRIC SELECTOR SWITCH (Rear
Control Dryers)
a. Pull fabric selector switch knob off shaft.
b. Remove three screws holding control hood
assembly to control hood rear panel.
c. Rotate assembly forward to access inner
wiring.
d. Disconnect wiring from switch and carefully
remove switch from control hood assembly.
NOTE: Refer to wiring diagram when rewiring
component parts.
e. Carefully lift locking tab holding fabric selector
switch to support control panel.
f. With locking tab lifted, rotate fabric selector
switch counterclockwise 1/4 turn and remove
switch out rear of support control panel.
27. SIGNAL (Rear Control Dryers)
a. Carefully pull signal knob off shaft.
b. Remove three screws holding control hood
assembly to control hood rear panel.
c. Rotate assembly forward to access inner
wiring.
d. Disconnect wires to the signal.
NOTE: Refer to wiring diagram when rewiring
component parts.
e. With locking tab lifted, rotate signal
counterclockwise 1/4 turn and remove signal
out rear of support control panel.
28. EXTEND TUMBLE SWITCH (Rear Control
Dryers)
Refer to
a. Remove three screws holding control hood
assembly to control hood rear panel.
b. Rotate assembly forward to access inner
wiring.
c. Disconnect wires from switch.
NOTE: Refer to wiring diagram when rewiring
component parts.
d. Remove switch through front of panel.
Summary of Contents for FES17AxF
Page 2: ......
