Operation
F232198
12
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Display
Meaning
tESt
Diagnostic test cycle selected or enabled
SPIn
Spin (extract) step
SUP1
Supply signal 1 (“S1” output), normally detergent
SUP2
Supply signal 2 (“S2” output), normally bleach
SUP3
Supply signal 3 (“S3” output), normally softener
SUP4
Supply signal 4
SUP5
Supply signal 5
SUP6
Supply signal 6
SUP7
Supply signal 7
SdLY
Spin coast (motor coasts after high speed extract)
CFIL
Cold Fill
HFIL
Hot Fill
bFIL
Warm Fill (cold + hot)
PASS
Variable-speed ONLY – balance “PASS” condition; shows in “test” cycle only
FAIL
Variable-speed ONLY – balance “FAIL” condition; shows in “test” cycle only
bAL?
Variable-speed ONLY – meaning: “Do you wish to enter balance detection test routine?”
CY__
Cycle number (followed by number 1 through 46)
SPn1
Variable-speed ONLY – low spin speed (the lowest of 3 spin speeds)
SPn2
Variable-speed ONLY – medium spin speed (the middle of 3 spin speeds)
SPn3
Variable-speed ONLY – high spin speed (the highest of 3 spin speeds)
For
Wash speed forward (during test cycle)
rEv
Wash speed reverse (during test cycle)
dISt
Variable-speed ONLY – distribution speed (during test cycle)
LO
Low water level
n
Ed
Medium water level
HI
High water level
CEL
Display all temperatures in degrees Celsius
FAr
Display all temperatures in degrees Fahrenheit
rIn5
“Rinse 5” segment
rIn6
“Rinse 6” segment (final rinse)
AG1
Agitation 1: 18 seconds forward, 3 seconds off, 18 seconds reverse, 3 seconds off
AG2
Agitation 2: 3 seconds forward, 27 seconds off, 3 seconds reverse, 27 seconds off
AG3
Agitation 3: 10 seconds forward, 20 seconds off, 10 seconds reverse, 20 seconds off
AG4
Agitation 4: 4 seconds forward, 56 seconds off, 4 seconds reverse, 56 seconds off
Table 1
