M413438
75
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 6
Adjustments
93. LEVELING LEGS
NOTE: It is recommended that the front of the
tumbler be kept slightly higher than the rear
(approximately 1/8 inch, 3.0 mm). This will prevent
clothes, while tumbling, from wearing on the door
glass gasket.
a. Check front to rear level by rotating clothes
cylinder until one of the cylinder ribs is at the
bottom. Place a level on the rib.
b. Check side to side level by placing a level on
the front and rear of top panel.
c. Front leg adjustment fittings are accessed by
removing lint panel door. Rear adjustment
fittings are located on rear corner braces.
Adjust legs as needed.
NOTE: Keep tumbler as close to the floor as
possible. All four legs must rest firmly on the floor
so weight of tumbler is evenly distributed. Tumbler
must not rock.
d. Replace lint panel.
