Entering the Manual Mode
For programming, testing, and retrieving information from the
control, it is often necessary to enter the Manual Mode by follow-
ing the steps below.
For an overview of entering the Manual Mode, refer to the flow-
chart.
How to Enter the Manual Mode
1.
Control must be in Idle Mode.
2.
Press and hold the Stop keypad, then press and hold the Back
keypad, then press the Up keypad.
3.
The display will show
Prog
.
4.
Press the Up or the Down keypad to scroll through the options
until the desired option appears in the display.
5.
Press the Start keypad to enter the displayed mode.
6.
To exit, press the Back keypad. The control will revert back to
Idle Mode.
Manual Programming can only be turned on or off with an exter-
nal device. Refer to the appropriate instruction manual. Diagnos-
tics can be turned on and off using an external device by manual
programming.
By default, Manual Programming is turned
on
.
The manual features available in each group are as follows (the
menu displayed on the display in this mode is in parentheses).
Manual Programming (
Prog
)
Manual Read Audit (
Audit
)
Manual Reset (
rESEt
)
Diagnostic Tests (
diAg
)
If a manual parameter is turned off or unavailable (ex: trying to
enter diagnostics while a cycle is running), the display will
change from the selected feature to
oFF
, an audio signal will
sound for one second and the features in the parameter cannot be
entered. The display will then return to the selected feature.
Entering the Manual Mode
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
25
Part No. 70444901ENR10
Summary of Contents for CHD25E2-CT025E
Page 2: ......
