M413487
43
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
59. FAN ASSEMBLY
Refer to Figure 19 or Figure 20.
a. Support corner drive guard and remove screws
holding corner guard to rear of tumbler. Refer
to Figure 13.
b. Support drive guard cover and remove screws
holding guard to rear of tumbler. Refer to
Figure 13
c. Loosen fan belt with adjusting nuts. Refer to
d. Remove fan belt.
e. Remove fan pulley.
f. Remove step pulley assembly.
g. Remove nuts holding fan assembly to rear of
tumbler.
h. Remove blower cover and fan assembly from
tumbler.
i. Remove screws holding tapered bushing to fan.
j. Remove tapered bushing by putting the screws
removed in step “h” into the threaded holes in
the bushing. Turning the screws inward will
force the bushing off the fan.
k. Remove fan from blower shaft.
NOTE: If replacing a worn bushing with a new one,
do not use the screws that come with a newly
ordered bushing. Reuse the longer old bushing
screws or order the screws shown in the parts
manual.
MODELS BUILT BEFORE 4/9/98
Figure 19
T337PE1B
FAN
BLOWER
COVER
BUSHING
FAN
PULLEY
BLOWER
SHAFT
BUSHING
FAN
BELT
FAN
MOTOR
ADJUSTING
NUTS
FAN
MOTOR
BASE
FAN
MOTOR
PULLEY
BUSHING
