Alliance Laundry Systems 802749r1, Instalation Instructions

Page: 4 / 12

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749
4
NOTE: Longer fill hoses are available (as optional
equipment at extra cost) if the hoses supplied with
the washer are not long enough for the installation.
Order hoses as follows:
No. 20617 Fill Hose 8 feet (2.44 m)
No. 20618 Fill Hose 10 feet (3.05 m)
IMPORTANT: Hoses and other natural rubber
parts deteriorate after extended use. Hoses may
develop cracks, blisters or material wear from the
temperature and constant high pressure they are
subject to.
All hoses should be checked on a monthly basis for
any visible signs of deterioration. Any hose showing
the signs of deterioration listed above should be
replaced immediately. All hoses should be replaced
every five years.
Step 3: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by unhooking the hose from the
retainer clamp and by removing the shipping tape.
Install the drain hose into the drain receptacle
(standpipe, wall or laundry tub) following the
instructions below.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 1-1/4 inch (3.2 cm) outside
diameter drain hose.
TLW1976N
1 Water Faucet
2 Fill Hose
3 Plain Rubber Washer
4 Hose Coupling
5 Filter Screens
Figure 3
HOT
COLD
3
1
5
2
4
FLW1973N
1 Water Faucets
2 Cold Water Connection
3 Hot Water Connection
4 Fill Hoses
Figure 4
FLW1973N
1
2
3
4