allen AW16-K 2019, Safety & Operation Manual

Page: 46 / 62

Dump Control Lever
A
A
SECTION A-A
REF. FRAME
7
3
2
1
8
7
4
10
9
9
5
6
4
7
8
3
REF. FRAME
SIDE VIEW
1) Console mounted dump control lever
Three (3) adjustments are possible: Position of foot pedal, drag on valve lever pivot, and drag on dump
pedal pivot.
1. Position of foot pedal: To readjust foot pedal position remove cotter pin (6) and clevis pin (5) at
pedal. Loosen hex jam nut (7) and turn clevis (4) clockwise to lower pedal, counterclockwise to raise
pedal. Replace clevis pin (5) and cotter pin (6). Tighten hex jam nut (7).
2. Drag on valve lever (1) Pivot: This lever should return easily to neutral position. To change drag, loos-
en hex locknut on bolt assembly (3). Tighten hex nut to increase drag. Loosen hex nut to decrease
drag. Tighten locknut to 25-ft. lbs. Spray with lube after adjustment.
3. Drag on dump pedal pivot (9)t: same as adjustment 2 above except adjustment is made on bolt
assembly (10) and locknut is torqued to 120-ft. lbs. Spray with lube after adjustment.
4. Apply approved lubrication to all bucket dump lever points.
Dump Lever Adjustment
SECTION 3
SERVICE
069583 Page 46