ASSEMBLY INSTRUCTIONS
5
Attach mounting plate (B) to outlet box (not included)
using existing washers and outlet box screws or the
machine screws (BB).
NOTE
: If the outlet box screws
required for your outlet box are of a different size
than the machine screws (BB), consult a licensed
electrician before proceeding. Tighten machine
screws (BB) to secure mounting plate (B).
Then, screw fixture screws (CC) into plastic anchors
(DD).
CAUTION:
Make sure the outlet box can support
35 lbs. hanging weight. Use
metal
outlet box; plastic
outlet boxes are not recommended.
4.
5.
Hardware Used
Machine Screw
x 2
BB
4
A
Pilot Hole
DD
Determine the approximate location for the fixture
(A). Place mounting plate (B) against the wall and
mark the location of the hole using a pencil or a
marker (not included).
Set mounting plate (B) aside. Then, using a 1/8 in.
drill bit (not included), drill a pilot hole at the
marked location. Position plastic anchor (DD) in
the pilot hole. Gently tap plastic anchor (DD) with
a hammer (not included) until flush with wall
surface.
3. Remove mounting plate (B) from fixture (A) by
removing mounting plate screws (C) from the
edges of the fixture (A).
Save mounting plate screws (C) for later use
.
5
B
BB
BB
CC
CC
Outlet Box
DD
3
B
C
A
C
