4
AA
DD
FF
Washer
Cap
HH
Wrench
KEEP ALL FLAME AND HEAT AWAY FROM THIS TENT FABRIC.
Please read and understand this entire manual before attempting to assemble or install the product.
Two to four people are need for assembly.
Maximum load for the roof hook: 50 lbs.
.
.
.
.
.
x 8
x 2
x 8
x 8
SAFETY INFORMATION
WARNING:
CAUTION
PREPARTION
INSTALLATION INSTRUCTIONS
Hardware Used
This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous
contact with any flame source. The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
Do not leave outside during high winds, heavy rains or snow. If high winds, heavy rains or snow
occurs, remove canopy and mosquito net, clear snow load from roof tube, and check for damage
before continued use.
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble
the product.
Estimated Assembly Time:
2-3 hours
Tools Required for Assembly (not included): Ladder
Tools Required for Assembly (included): Wrench
1. Insert the post plate cover (C) into the supporting
post (A). Fit the post bottom plate (B) underneath
the supporting post (A). Insert two M6
x 15 mm
bolts
(AA) into the washers (DD), supporting post (A) and
secure to the post bottom plate (B) using the
wrench (HH), but do not overtighten. Place caps
(FF) on the bolt heads. Slide the post plate cover
(C) down into place.
Repeat this step for the remaining supporting posts
(A), post bottom plates (B) and post plate covers (C).
M6 x 15 mm Bolt
1
FF
B
C
A
C
A
A
C
C
B
B
AA
AA
DD
DD
FF
FF
