Allen-Bradley SLC 500 DeviceNet, User Manual, Page: 130 / 139

Publication 1747-6.5.5 - August 2000
H-2 Installing and Configuring the ControlNet Communications Driver
These settings depend on the devices installed on your computer. We
used the following addresses:
When deciding which addresses to use, remember that each card
in your computer must have a unique base memory address and a
unique base I/O space memory address. If another card in the
host computer is using one or both of the selected addresses, you
must change the card’s switch settings to an available address.
3. Insert the card in a vacant 16- or 32-bit ISA/EISA expansion slot.
Configuring the 1784-KTCX15 Communications Driver
After installing the card in the computer, you must run RSLinx to
configure the driver.
1. Start RSLinx .
2. Select Configure Drivers from the Communications menu.
Front View
Side View
down (0)
up (1)
up (1)
down (0)
S3
240h shown
(adjust for your system)
Front of Switches
Base I/O Space Address 240
Base Memory Address D000:000
TIP
Consult with your IT/PC support group to find
out if it is necessary to change any of your
computer’s memory address or IRQ settings.