Allen-Bradley PowerFlex 20-COMM-P, User Manual, Page: 11 / 117

Getting Started 1-3
Equipment Shipped with the Adapter
When you unpack the adapter, verify that the package includes:
User-Supplied Equipment
To install and configure the PROFIBUS adapter, you must supply:
Required Equipment
❑
One PROFIBUS adapter
❑
A 2.54 cm (1 in.) and a 15.24 cm (6 in.) Internal Interface cable
(only one cable is needed to connect the adapter to the drive)
❑
One grounding wrist strap
❑
One floppy disc with GSD file
❑
This manual
❑
A small flathead screwdriver
❑
PROFIBUS cable
❑
One 9-pin, male D-Sub PROFIBUS connector.
[
Note
: PROFIBUS connectors are available from a variety of sources
and in various sizes. As such, there may be mechanical limitations
that prohibit the use of some connectors. Phoenix Subcon Plus M1
(Part # 2761826) or ERNI Profibus vertical (Node Part # 103658 and
Termination Part # 103659), are recommended for use with
PowerFlex 70/700 drives.]
❑
Configuration tool, such as:
– Pow erFlex HIM
– DriveExplorer (version 2.01 or higher)
- with 1203-SSS Serial Converter (version 3.001 or higher)
– DriveExecutive (version 1.01 or higher)
- with 1203-SSS Serial Converter (version 3.001 or higher)
❑
PROFIBUS configuration software
❑
Controller configuration software
20COMM-UM006A-EN-P.book Page 3 Friday, September 28, 2001 10:43 AM