Allen-Bradley PowerFlex 20-COMM-D, User Manual

Page: 20 / 149

2-6 Installing the Adapter
1. Close the door or reinstall the cover on the drive. The status
indicators can be viewed on the front of the drive after power has
been applied.
2. Ensure that the adapter will have a unique address on the network
and is set at the correct data rate or to autobaud. If a new data rate or
address is needed, reset its switches (refer to
Commissioning the
Adapter in this chapter).
3. Apply power to the network.
4. Apply power to the PowerFlex drive. The adapter receives its power
from the connected drive and network. When you apply power to the
product and network for the first time, the status indicators should be
green after an initialization. If the status indicators go red, there is a
problem. Refer to
Chapter 7 , Troubleshooting .
5. If the data rate switch is set to “PGM,” use a configuration tool to set
the data rate and node address parameters in the adapter (
Chapter 3 ,
Configuring the Adapter ). If you are using RSNetWorx for
DeviceNet, you need to create a point-to-point connection to the
drive.
6. Apply power to the master device (scanner) and other devices on the
network.
Applying Power
!
ATTENTION: Risk of equipment damage, injury, or death exists.
Unpredictable operation may occur if you fail to verify that parameter
settings and switch settings are compatible with your application.
Verify that settings are compatible with your application before
applying power to the drive.