Allen-Bradley PowerFlex 20-COMM-D, User Manual

Page: 11 / 149

Getting Started 1-3
The DeviceNet adapter is compatible with Allen-Bradley PowerFlex
drives and other products that support DPI. DPI is a second generation
peripheral communication interface. It is a functional enhancement to
SCANport. At the time of publication, compatible products include:
•
PowerFlex 70 drives
•
PowerFlex 700 drives
•
PowerFlex 7000 drives
Equipment Shipped with the Adapter
When you unpack the adapter, verify that the package includes:
User-Supplied Equipment
To install and configure the DeviceNet adapter, you must supply:
Compatible Products
Required Equipment
❑
One DeviceNet adapter
❑
A 2.54 cm (1 in.) and a 15.24 cm (6 in.) Internal Interface cable
(only one cable is needed to connect the adapter to the drive)
❑
One five-pin linear DeviceNet plug
(connected to the DeviceNet connector on the adapter)
❑
One grounding wrist strap
❑
This manual
❑
A small flathead screwdriver
❑
DeviceNet cable
– Thin cable with an outside diameter of 6.9 mm (0.27 in.) is
recommended
❑
Configuration tool, such as:
– PowerFlex HIM
– DriveExplorer (version 2.01 or higher)
– DriveTools 2000 (version 1.xx or higher)
– RSNetWorx for DeviceNet
– Smart Self-powered Serial Converter (1203-SSS, v3.001 or higher)
❑
Computer with a DeviceNet communications adapter installed
(Examples: 1784-PCD, 1784-PCID, 1784-PCIDS, or 1770-KFD)
❑
Controller configuration software
(Examples: RSLogix5, RSLogix500, or RSLogix 5000)