Allen-Bradley PowerFlex 20-comm-c FRN 1. Series, User Manual

Page: 31 / 159

Configuring the Adapter 3-7
To set the fault configuration parameters
If you set Parameter 10 - [Comm Flt Action] , or 11 - [Idle Flt Action]
to the “Send Flt Cfg,” the values in the following parameters are sent to
the drive after a communications fault and/or idle fault occurs. You must
set these parameters to values required by your application.
Changes to these parameters take effect immediately. A reset is not
required.
Changes to switch settings or some adapter parameters require that you
reset the adapter before the new settings take effect. You can reset the
adapter by cycling power to the drive or by using the following
parameter:
•
Set the Parameter 09 - [Reset Module] to Reset Module :
Figure 3.6 Reset Screen on an LCD HIM
Number Name Description
15 Flt Cfg Logic A 16-bit value sent to the drive for Logic Command.
16 Flt Cfg Ref A 32-bit value (0 – 4294967295) sent to the drive as a
Reference or Datalink.
Important: If the drive uses a 16-bit Reference or 16-bit
Datalinks, the most significant word of the value must be
set to zero (0) or a fault will occur.
17 – 24 Flt Cfg x1 In
Flt Cfg x2 In
Resetting the Adapter
!
ATTENTION: Risk of injury or equipment damage exists. If the
adapter is transmitting control I/O to the drive, the drive may fault when
you reset the adapter. Determine how your drive will respond before
resetting a connected adapter.
Value Description
0 Ready (Default)
1 Reset Module
2 Set Defaults
Port 5 Device
20-COMM-C
Parameter #: 9
Reset Module
1
Reset Module
20COMM-UM003A-EN-P.book Page 7 Wednesday, November 7, 2001 3:46 PM
Spare Allen-Bradley Parts