122
Rockwell Automation Publication 2198-UM004A-EN-P - October 2019
Chapter 7
Configure the Drive with KNX5100C Software
5.
If you select the first option, an uploading message box appears until the
process is completed.
6.
In the Communication Setting dialog, communication status is shown as
online.
Set the IP Address
You can change the IP address (network) setting through the Function List.
To change the IP address, perform the following steps.
1.
Under the Function List, click Drive IP Address Setting.
2.
Choose between STATIC IP and DHCP.
If Static IP, then configure the IP address, Gateway, and Subnet mask.
For more information on setting the network parameters, refer to
,
IMPORTANT
Settings are stored in nonvolatile memory, and changes to the IP
addressing take effect after power is cycled.
Summary of Contents for Kinetix 5100 2198-E1004-ERS
Page 499: ......