Publication 1784-6.5.30 - February 2001
5-8
Using IOLinx To Test the Example Network
4.
Pass your hand back and forth over the photoeye several times.
On your screen you should see input byte 1 toggling back and
forth between “0” and “1” as the photoeye input turns on and off.
Testing the RediSTATION Output
Recall from Chapter 5 that the RediSTATION’s indicator light is
mapped to Output Word 0, bit 0.
1.
If the scanner is not in
RUN
mode, use the
Switch Mode
button
to change the scanner’s mode from
IDLE
to
RUN
.
2.
Select byte 0 from the Output table, type in a “1” in the
New
Value
field and click on the
Write
button. The red indicator light
on the RediSTATION should turn on.
3.
Select byte 0 from the Output table, type in a “0” in the
New
Value
field and click on the
Write
button. The red indicator light
on the RediSTATION should turn off.
Summary of Contents for DeviceNet 1784-PCIDS
