Allen-Bradley armorstratix 5700, User Manual, Page: 70 / 458

70 Rockwell Automation Publication 1783-UM007I-EN-P - December 2017
Chapter 2 Get Started
Command-line Interface Apart from Device Manager and the Logix Designer application, you can
manage the switch from the Cisco IOS command-line interface (CLI). This
interface enables you to execute Cisco IOS commands by using a router
console or terminal or by using remote access methods.
You can use the following connection methods:
•
Connect directly to the switch console port
•
Enable Secure Shell (SSH) or Telnet in Device Manager
For more information about using the CLI, refer to www.cisco.com .
Connect to the Console Port
1.
Connect to the console port in one of these ways:
•
To connect to the standard 9-pin serial port on a computer, use an
RJ45-to-DB-9 adapter cable.
•
(Stratix 5400, 5410, 5700, and ArmorStratix 5700 switches). Use a
standard mini-USB cable to connect to the mini-USB port on a
computer. If you use the USB cable, download the drivers
from
http://www.rockwellautomation.com .
2.
Connect the other end of the cable to the console port on the switch.
3.
Start a terminal-emulation program on the computer.
4.
Configure the computer terminal emulation software for 9600 bps,
eight data bits, no parity, one stop bit, and no flow control.