Rockwell Automation Publication 6300B-UM002A-EN-P - October 2020
15
Chapter 2 Install the Wall Mount Box PC
Mounting Requirements
Follow these requirements to mount the VersaView 6300B wall mount box PC.
•
Choose a suitable mounting height
•
For optimal performance, mount the computers in the vertical
(upright) position, so the I/O ports face down.
•
To help prevent overheating and to provide access to the I/O ports for
cable connections, mount the computer so there are the following
minimum clearances:
- X and Z directions: 7 cm (2.75 in.)
- Y direction: 10 cm (3.94 in.)
Required Tools and
Hardware for Installation
The following tools and hardware are needed for wall mount installations.
•
A drill and drill bit
•
#2 Phillips screwdriver
•
Four M4x20 stainless steel screws (customer supplied)
•
Safety glasses
Install the Wall Mount Box
PC
There are two preferred methods to install the computer.
Install Method 1
1.
See Method 1 in
to locate and drill holes for the four
M4x20 stainless steel screws.
2. Align the holes on both computer brackets with the four drilled holes.
3. Install the computer with the four customer-supplied screws.
4. Tighten the four screws.
Install Method 2
1.
See Method 2 in
to locate and drill holes for the four
M4x20 stainless steel screws.
2. Install the four customer-supplied screws but leave enough space to
hang the brackets.
3. Align the four keyhole slots on both computer brackets with the four
installed screws.
IMPORTANT
The vertical position can be tilted up to 20° forward or backward
from the upright position. However, any tilt angle reduces the
maximum operating temperature by 5 °C (41 °F).
Y
Y
X
X
Z
I/O Ports Face Down
Vertical (Upright)
Position
0°
(preferred)
20°
max
20°
max
