Power Supply Modules
(Cat. No. 1771P4R and P6R)
Installation Data
8
To connect a wire to a terminal:
1.
Strip 0.35 inches of insulation off the wire.
2.
Spring the clip open open to insert the wire, using a wedge-tipped
tool such as a small screw driver If you leave the terminal block
plugged into the supply, insert the tool parallel to the wire (push
straight in). If you remove the terminal block and lay it on a flat
surface, insert the tool perpendicular to the wire (push straight down).
3.
After making the wiring connections, re-insert the terminal block into
the front plate if you removed it. Be sure that the plug is completely
inserted and that the locking prongs are engaged.
Figure 5
Connecting a Wire to a Terminal
Once you have completed the tasks up to this point, you can turn the power
switches on. Turn all the power switches on at the same time. If everything
is set up correctly, all P/S ACTIVE (green) indicators will be on and all
NON REDUNDANT SYSTEM (yellow) indicators will be off.