Rockwell Automation Publication 1769-UM021G-EN-P - October 2015
25
Install the CompactLogix 5370 L1 Controller
Chapter 1
3.
If you are not using local expansion modules, use the tongue-and-groove
slots on the right side of the controller to slide a protective covering onto
the controller. The protective cover ships with the controller.
The covering covers the exposed interconnections on the right side of the
controller. Failure to use a protective covering can result in equipment
damage or injury from electric shock.
If you are using local expansion modules, see
for more information on how to install them in a
CompactLogix 5370 L1 control system.
Install the Removable Terminal Block
A removable terminal block (RTB) is supplied with your wiring base assembly. To
remove, pull up on the RTB handle. This allows the mounting base to be
removed and replaced as necessary without removing any of the wirings. To
reinsert the removable terminal block, proceed as follows:
1.
Insert the end opposite the handle into the base unit. This end has a curved
section that engages with the wiring base.
2.
Rotate the RTB into the wiring base until it locks itself in place.
3.
If an I/O module is installed, snap the RTB handle into place on the
module.
Thermocouple
Input
Module
Status
Network
Status
1734
IT2I
NODE:
0
1
Insert the module straight
down into the mounting base.
Hook the RTB end into
the mounting base
end and rotate until it
locks into place.
44012
