62
Rockwell Automation Publication 1756-UM010C-EN-P - June 2021
Chapter 4 Install the Configurable Flowmeter Module
Standard Prover/Detector Wiring Example 1
• Detectors #1 and #2 must be wired in parallel.
• Customer VCC can be used to power detectors. In this case, though, the maximum current on the wiring arm must be
less than 4A.
• The wiring example above shows a 12-24V DC standard prover connected to the module.
If you use a 5V DC standard prover, make sure the positive wire is connected to the 5V terminal (e.g. Z0 5V DC).
• If separate power sources are used, do not exceed the specified isolation voltage.
12-24V DC
Shield ground
Flowmeter
Device
Z0 12-24V DC
Z0 5V DC
Z0 Return
Customer VCC
F0
F0 Return
Not used
Not used
Output 0
Customer VCC
Z1 12-24V DC
Z1 5V DC
Z1 RET
Not used
Customer Common
Not used
Output 1
F1
F1 Return
Customer Common
+
–
Shield ground
+
–
Detector #1
Detector #2
2
4
6
8
10
12
14
16
18
20
1
3
5
7
9
11
13
15
17
19
