XONE:62
User Guide
Quick Start
We recommend that you read through all sections of this User Guide before starting. However, we
provide these notes so that you can plug up and experiment with sounds from your
XONE:62
immediately if you prefer to read the full guide later. Please note that you should first read and
understand the
Important Safety Instructions
printed at the beginning of this guide. The following
simple procedure requires a CD player and headphones. Alternatively you can connect a pair of
turntables and start mixing right away. Please read the rest of this guide before connecting to your
amplifier and speaker systems.
1
Set all controls to their starting condition
. Set all
FADERS, GAIN, AUX, VCF, RESONANCE, HEADPHONES
and BOOTH MONITOR controls minimum. Set PAN and EQ
controls to their detented centre position. Set all switches to
their up position.
2
Plug in a CD player
. This provides a good stereo audio
source as a starting point. Plug into CH3 line input as shown.
Do not use the phono input for CD or other line level sources as
this is intended for turntables with magnetic cartridges requiring
RIAA equalisation.
3
Plug in the headphones
. Plug into the top panel
PHONES socket. Use the best headphones you can afford for
your application. We recommend the professional grade
closed-ear type of 30 to 100ohms impedance, and with ¼” TRS
jack plug. Avoid using the popular mini jack to ¼” adapters as
these can quickly prove unreliable.
4
Connect AC mains power
. Check first that the correct
mains lead with sealed plug suitable for your local supply has
been provided with your console. Plug into the AC MAINS IN
socket making sure the connector is pressed fully in.
5
Switch the console on
. Press the rear panel ON/OFF
switch. Check that the green and red XY leds above the
crossfader both light. You may notice that the console meters
flash briefly. This is normal during power up.
6
Select the line source
. Press the CH3 source select
switch. This lights red to indicate that the line source is
selected.
7
Adjust the channel gain
. Start the CD player. Adjust
CH3 GAIN control until the average music level lights the
channel meter green 0 led with loudest peaks lighting the yellow
+6 led. If no signal is present check that the music source is
playing and the correct input is selected.
.
Reduce GAIN if the red PK Led lights. This indicator
is a warning that the signal is approaching clipping and
that distortion may result if the level increases further.
AC MAINS IN ~
0
I
