D Reinstall adjustment plate.
Tighten until door thickness insert enters notch in adjustment
plate.
E Secure chassis in outside assembly.
Continue to next step.
Install Outside Assembly
1
Prepare outside assembly.
1a Check that slide hole on chassis is aligned with lever
catch pin.
If not aligned, remove chassis and reassemble with correct
orientation as shown below.
LH
OR
RH
To remove chassis, pull lever post and rotate 10 degrees
counter-clockwise as shown below until adjustment plate tabs
align with cutouts on assembly.
1b To change handing, pull lever post until it stops, then
rotate 180 degrees.
Align lever catch pin and slide hole to latch side. Release
lever post. Assembly will click into place.
CAUTION
Do not route ribbon cable before rotating chassis!
Lever Catch Pin
1
2
3
Do not route
ribbon cable!
1
2
3
1c Connect chassis cable. Route cables.
The cable should be routed on top of the chassis! Connect
cable from outside assembly to connector in chassis.
Push and tuck cable.
Route cable in plastic channel.
Route cable in metal channel.
LH
Connect cables.
OR
RH
Push and tuck cable.
Route cable in metal channel.
Connect cables.
Route cable in metal channel.
Tuck connected chassis cable into appropriate channel.
