4 Initial operation
© 2022 Interflex Datensysteme GmbH | IF-4735 Time Recording Terminal | 04.22
20
4.5 Restarting the controller
Some changes require a restart of the controller. You can do this directly on the controller or with
the appropriate commands via the console.
1
2
1
2
3
3
Reset button
DIP switches
RUN LED
Warm boot
A warm boot performs the following actions:
n
Close application
n
Restart application
Associated console command:
oc -s
or
factory-reset application-restart
Reboot
A reboot performs the following actions:
n
Close application
n
Shut down operating system
n
Boot operating system
n
Restart application
1. Set switches:
2. Shortly press the Reset button
3. Wait until the RUN LED lights up again (procedure can take up to 30 seconds)
Associated console command:
factory-reset reboot
Cold boot
All settings made on the controller via IF-6040 or OC Task are deleted or reset to default. System
or operating system settings, such as the IP address or password, are retained.