Alinco DR-620, Service Manual

Page: 44 / 56

This adjustment-mode sequence is valid only for T/TA and E versions.
2 ) A d j u s t m e n t M o d e
Adjusment memory table
Memory
CH VHF Freqency
[MHz] UHF Freqency
[MHzl
Contents
CH1 146.000
440.000 PD Voltage
CH2 146.000
440.000 Ref Frequency
CH3 146.000 (145.000)
440.000 (435.000) Hi Power
CH4 146.000 (145.000)
440.000 (435.000) Mid Power
CH 5
146.000 (145.000) 440.000 (435.000) Low Power
CH6 146.050
440.050
RX Distortion
CH7 136.050
400.050 RX Sensitivity L
CH8
146.050
440.050 RX Sensitivity M
CH9 173.950 479.950 RX Sensitivity H
CH10 146.050 440.050
S Meter 1
CH11 146.050
440.050 S Meter FULL
CH12 146.050
440.050
Squelch
CH13 87.700
RX Distortion
CH14 87.700
S Meter 1
CH15 87.700
S Meter FULL
CH16 146.000 (145.000) 440.000 (435.000) TX Deviation
CH17
146.000 (145.000) 440.000 (435.000) TX Deviation NAR
CH18 146.000 (145.000)
440.000 (435.000) Mic Gain
CH19 146.000 (145.000)
440.000 (435.000)
CTCSS 88.5Hz
CH20
146.000 (145.000) 440.000 (435.000) DCS 255
CH21 146.000 (145.000) 440.000 (435.000) Tone Burst 1750Hz
CH22 145.050 435.050
aging
( ) = DR620E
After the above frequency is written in the memory,
it is set on the adjustment mode by the following operation.
FUNC^TS/DCS (Key Lock)
BAND->CALhMHz^MHz->TS/DCS->H/L^H/L
Memory switching of VHF and UHF can be done with the BAND key.
Adjustment mode is canceled when a power switch is turned on with CALL key.
[Cautions]
In RX Sensitivity adjustment^,Mand H),the following inequality must be realized.
CH7(L) < CH8(M) < CH9(H)
[Example CH7=5A CH8=60 CH9=E0]
44