Figure 5
PAIR indicator
located on
right side of
Motion Sensor
Match PAIR on Motion Sensor
to PAIR on Base
1. Universal Status Indicator
Illuminates at varying times:
when Motion Sensor is turned
on, pairing with Alarm Base is
complete, or infrared beam is
broken
2. Infrared Motion Sensor
Infrared beam detects motion
3. On/Off Switch Turns Motion
Sensor on or off
4. Pair Status Indicator
Illuminates when Alarm Base
is in range for pairing
5. Battery Compartment
Button Press to open battery
compartment
6. Universal Wall Mount and
Bracket Holds Motion Sensor
and mounts to wall
Intended Use
Key Features
The AliMed ONE Wireless Motion Sensor pairs with the Alarm Base to provide caregiver notification of patient falls or elopement as part of an overall fall
management program. The Motion Sensor can be mounted to a wall for wandering protection anywhere in the room.
Figure 1
2.
5.
1.
6.
Setup and Operating Instructions
The Motion Sensor is installed by Nurse or Biomedical staff.
1. Motion Sensor requires one (1) 9V battery to operate (sold separately, see reverse).
2. Press the Battery Compartment Button (Fig. 3) to open the battery compartment.
3. Align the male and female connectors on the top of the battery to the connectors
attached to the unit. Place in battery compartment.
4. The Motion Sensor is now ready for pairing.
5. Close the battery compartment door until it snaps into place.
Pairing the Motion Sensor with the Alarm Base:
1. Ensure the On/Off Switch is set to the “OFF” position (Fig. 2).
2. Press Pair Button on the Alarm Base.
3.
The Base will beep and the first open channel will blink green and red indicating
channel is ready for pairing.
4. Place Motion Sensor next to the Base matching PAIR on the Motion Sensor to PAIR
on the Base (Fig. 4). Note: Pair Status Indicator on Motion Sensor (Fig. 3) will
illuminate when in range of the Base.
5. If pairing is successful, the Base will beep and the assigned channel will blink green
once. The Universal Status Indicator (Fig. 1) on Motion Sensor will blink three (3)
times.
6. The Motion Sensor is now paired with the Base. The assigned channel on the Base
will continuously blink at approximately 5-second intervals indicating Motion Sensor
is in use.
Figure 4
Figure 2
Figure 3
3.
4.
AliMed ONE
™
Wireless Motion Sensor
Instructions for Use, Setup, and Care
