Removing the coin-cell battery
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
Before working inside your computer
. After working inside your computer, follow the instructions
After working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
CAUTION: Removing the coin-cell battery resets the BIOS setup program’s settings to default. It is recommended
that you note the BIOS setup program’s settings before removing the coin-cell battery.
Prerequisites
1
Remove the
2 Remove the left and right side-panels. See “
3 If you have multiple graphics cards installed, remove the graphics card. See “
Removing multiple graphics cards
”.
Procedure
1
Lay the chassis on the right side.
2 Locate the coin-cell battery on the system board.
3 Push the coin-cell battery-release lever.
4 Remove the coin-cell battery.
68
Summary of Contents for Area-51 Threadripper Edition R7
