Alienware Area-51 R3 Threadripper Edition, Service Manual

Page: 98 / 199

Replacing the logo board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer . After working inside your
computer, follow the instructions in After working inside your
computer . For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance .
Procedure
1 Align the screw holes on the logo board to the screw holes on the bracket
and slide the logo board in place.
2 Replace the six screws (#6-32x6) that secure the logo board to the bracket.
3 Slide the logo board inside the chassis.
4 Replace the screw (#6-32x6) that secures the logo board to the bracket.
5 Route and connect the respective to the logo board.
Post-requisites
1 Replace the left and right side-panels. See “ Replacing the side panels ”.
2 Replace the stability foot .
98