Alienware Area-51 R3 Threadripper Edition, Service Manual

Page: 141 / 199

Replacing the handle bars
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer . After working inside your
computer, follow the instructions in After working inside your
computer . For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance .
Procedure
1 Align and place the bottom-handle bar on the slot and snap the bottom-
handle bar to the chassis.
2 Replace the seven screws (#6-32x6.5) that secure the bottom-handle bar to
the left side of the chassis.
3 Replace the seven screws (#6-32x6.5) that secure the bottom-handle bar to
the right side of the chassis.
4 Align and place the front-handle bar on the slot and snap the front-handle
bar to the chassis.
5 Replace the seven screws (#6-32x6.5) that secure the front-handle bar to
the left side of the chassis.
6 Replace the seven screws (#6-32x6.5) that secure the front-handle bar to
the right side of the chassis.
7 Align and place the rear-handle bar on the slot and snap the rear-handle bar
to the chassis.
8 Replace the seven screws (#6-32x6.5) that secure the rear-handle bar to
the left side of the chassis.
9 Replace the seven screws (#6-32x6.5) that secure the rear-handle bar to
the right side of the chassis.
Post-requisites
1 Replace the left and right side-panels. See “ Replacing the side panels ”.
2 Replace the stability foot .
141