TdC 8000 for Equestrian
Page 20
Version:E-00-08-08
Page 20
2.9.
Synchronize Start
Synchronization between TdC 8000 and other timing devices is possible. You synchronize the TdC
8000 after you adjust the time before you start the timing.
Connect other timers through banana socket of channel c0 of the TdC 8000 with a 1 pair cable (or
cable 004 at socket 19 or 20).
Time: 10:15:23
OK< F1
time on display
is
correct
Date: 96-02-28
WRONG F2
time on display
is not
Continue: ENTER
correct
There are two ways to make the synchronization:
-
Synchronization from the internal clock
-
Manual synchronization
Synchronization from the internal clock:
-
Press <F1>
-
Press <ENTER>
-
The info-display (6) shows:
Time: 10:15:45
Date: 96-02-28
Synchronize: on minute change
-
At the next sharp minute the TdC 8000 gives the synchronise impulse through channel c0.
-
At the synchronization it gives a beep form the TdC 8000.
-
The time of day disappears in the info-display (6).
-
The TdC 8000 is ready for timing.
Manual synchronization:
-
Press <F2>
-
Press <ENTER>
-
The info-display (6) shows:
Time: 10:15:34
Date: 96-01-16
Save with: ENTER
-
Input (correct) the time of day with the finish keyboard (15) and confirm with <ENTER>.
-
Input (correct) the date with the finish keyboard (15) and confirm with <ENTER>.
Time: 10:16:00
Date: 96-03-28
Synchronize: START-key / channel C0
-
Start the timers by pressing the <START> key or through an external impulse of channel c0.
-
The TdC 8000 is ready for timing.