ALGE-Timing OPTIc3, Manual

Page: 106 / 121

Manual
Photo Finish OPTIc3
- 106-
20.1.2 Mylaps
Device: MyLaps Orbits
connected via network:
TCP Client: IP Adresse von PC + Port 50000
You must activate the output of display on the computer.
connected via RS232 interface with 9600/n/8/1
connection on serial port of computer
You must activate the output of display on the computer.
Device: MyLaps X2
Channel: Enter the name of the loop that
is useed. Standard: S/F
Enabled: must be set to „True“
Host: enter IP-address of the X2
server
Password/Username: input password and username
of decoder;
standard settings: admin/admin
After changing the settings, restart the OPTIc3.NET software. If the MyLaps X2 panel is
green, the connection to the X2 Server is established. Otherwise, it will show orange and red.
If the panel is grey it is disabled.
20.2 Transponder Mapping
The transponder mapping is necessary to match the transponder ID with the competitor ID (bib).
Each transponder has a unique ID-code. This ID-code must be matched in the transponder
mapping with the bib of a competitor that carries this transponder.
The transponder mapping table can be integrated into the OPTIc3.NET software by reading an
Excel table. To start the import, click on
.