Alfresco ALXE series, Care And Use Manual

Page: 16 / 32

16
ADJUSTMENT STEPS:
1. Follow lighting instructions by setting the control
knob on “HI” and allow the burner to preheat for 10
minutes.
2. Turn the control knob to “LOW” and wait for the
burner temperature to drop and stabilize.
3. Attempting adjustment at any setting other than
LOW can create a dangerous condition.
4. Remove knob by pulling straight away from control
panel.
5. Insert a small blade screwdriver into the valve stem
to begin the adjustment.
6. Turn counter-clockwise to INCREASE the low heat
flame using pliers to hold the stem securely. ( see
figure # 5 )
7. Adjust the flames so the burner is fully lit around the perimeter when the knob is in the LOW posi-
tion. Once proper adjustment is reached, reattach the knob by pushing onto stem.
OPERATING THE GRILL:
BEFORE USING THE GRILL:

Make sure the grill has been leak tested .

Remove any packing material.

Read and understand the instructions in this manual.
U-BURNERS:
Each U-burner is rated at 27,500 BTU. (
See figure # 6 ).
The grill burners encompass the entire cooking area
and are side ported to minimize blockage from falling
grease and debris.
Above the burners there are stainless steel briquette
trays with ceramic briquettes. The briquette tray is a
fundamental part for the performance of the grill. Do
not cook on the grill without them.
Make sure the briquette tray is installed properly be-
fore lighting the burner. Each grill burner has its own
igniter.
The burners are locked in the proper position within the barbecue unit by the inlet port where the valve
orifice stem is located, the shutter adjustment screw notch and the rear mounting bracket at the back of
the grill cavity.
(See figure # 6a)
Figure # 5
Figure # 6
Figure # 6a
IGNITER
SHIELD
BURNER
SHUTTER
LOCATING
NOTCH
INLET PORT