Alfa Laval M line TS6, Instruction Manual

Page: 40 / 46

4
If the plates have been removed, insert them
in alternate directions and with the gaskets
turned towards the frame plate or pressure
plate as specified on the plate hanging list.
Use the marked line that was made when the
heat exchanger was opened, refer to step
7
on page 36 in Opening on page 34.
5
If the plate pack has been marked on the
outside, check this (see step
7 on page 36 in
Opening on page 34). If the plates are
correctly assembled (A/B/A/B etc.), the edges
form a “honeycomb” pattern, see picture.
6
Press the plate pack together. Position the
four tightening bolts according to the
figure.Tighten the four bolts (1), (2), (3), (4)
until the plate pack measure is 1.10×
A
making sure the frame plate and pressure
plate are parallel when closing.
1
4
3
2
200000423-1-EN-GB 40
6 Maintenance EN