Alfa Laval IsoMix External Drive, Instruction Manual

Page: 17 / 50

4 Installation
All position numbers and item numbers refer to the drawings shown and specified in chapter 8.1 IMXD without middle
section and 8.2 IMXD with middle section.
Step 9
1. Lift the drive section so the drive shaft (43) of the drive section is inserted into the bottom of the DN80 valve section (19).
2. When the two drive shafts (21 and 43) meet, turn the drive section until the two drive shafts slide together (can be seen
through the side port of the DN80 valve section (19)).
3. Slide the bonnet of the drive section into the DN80 valve section (19). Motor part of the drive section shall not be located
above the flange of the DN80 valve section (19). (NB: If a certain orientation of the electrical motor is needed, it can now be
turned into that orientation) and secure with Clamp ring (41).
4306-0017
1)
4306-0018
1)
1) Drive section
17