Installation
Lifting
Straps should be used when lifting the heat exchanger. Place straps according to picture with a
minimum angle of 45 ° .
Warning!
Never lift by the connections or the studs around them.
Figure 4. Lifting device for M15, TL10,
TL15, T20, TS20, Wide Gap100 and Wide
Gap200
Figure 5. Lifting device for MX25 and
MA30
Raising
This instruction is valid when raising the heat exchanger after delivery from Alfa Laval. Only use
a strap approved for the weight of the heat exchanger. Follow the principle of the instruction
below.
Caution!
The straps shall be long enough to be able to rotate the heat exchanger without
obstruction. Consider especially the space for the support column.
Step 1
Place two timber beams on the floor.
Document ID
Language
Edition
3490017599
EN
2016-06
Instruction Manual - Plate Heat Exchangers
13
EN
Summary of Contents for FrontLine WideGap 100
Page 2: ......