World leader in metal detection for anti-shoplifting purposes
900-1003114 Alert HyperGuard Quick pager MP10D (English V1)
Page: 8/9
Date:May 31, 2013
3.4 Repeater setup
Jumper Function
No. 1
Programming mode (
only
to be used when programming)
No. 2
This repeater is no. X
No. 3
This repeater is no. X
No. 4
No use
No. 5
No use
No. 6
No use
No. 7
No use
No. 8
No use
No. 9
No use
No. 10
No use
When the repeater is added to the Pager system do the following:
1. Set the repeater in program mode by placing the jumper in No.1
2. Switch the power on
3. Make sure that the distance between the repeater and pager transmitter is more than 3 meters.
4. Press the one of the bottoms on the Pager transmitter or activate an alarm in the EAS system.
If the programming is OK the TX led will flash at the same time as on the Pager transmitter
5. Switch the power off
6.
VERY IMPORTANT:
Set the transmitter in normal mode
Remove jumper No. 1
7. Switch the power on and test the system
8. Maximum 3 repeaters can be in a system.
They must be numbered 1-2-or 3 by setting the jumpers as described above
Jumpers
** No.1
** No.2
** No.3
** No.4
** No.5
** No.6
** No.7
** No.8
** No.9
** No.10
!
