Alencon SPOT: Installation,
Operation, and Maintenance Manual
16 |
P a g e
F
IGURE
14:
D
ISCONNECT
S
WITCH
C
LOSING
P
ROCEDURE
6.2 General Maintenance
6.2.1 Fuse Replacement:
Fuses within the AID enclosure can be replaced in the field if necessary.
Refer to manufacturer recommendations for the safe handling of fuse holders and
fuses in HV systems.
To replace fuses within the AID:
1.
Turn OFF the AID
2.
Open the AID enclosure, see section 6.1.1
3.
Use a multimeter to check internal fuses for continuity
4.
If any fuses are blown (discontinuous), open the fuse holder
5.
Remove dead fuse and replace with a new fuse of the same rating
6.
Close the fuse holder and use the multimeter to confirm it now passes a continuity test
7.
Close the AID enclosure, see section 6.1.2
8.
AID can be turned ON again
6.2.1 Additional Maintenance:
If AID still does not operate as expected, please contact Alencon Systems technical support for
assistance with troubleshooting (see Appendix C).
