First time use:
1. use the slider
to open the ACP-80
2. remove the battery compartment cover
3. activate the button cell by pulling out the insu-
lating strip from the ACP-80
4. install a 1.5V alkaline battery, paying attention
to the polarity (+ and -)
Replacing the button cell:
1. slide the white
tab to the right
until it releases
from the left
side
2. remove this tab
and replace the
button cell (the
+ upward)
3. replace the tab
to the right in
the opening, push it down and slide it to the left
until it secures the battery again
4. now press 1x the
RESET
button and set the
clock and alarm times again
Don’t discard exhausted batteries as normal
domestic waste, but bring them to a collec-
tion point for small chemical waste.
Setup:
clock:
1. unlock the buttons by sliding the
switch to
the left
2. press and hold the button for 2 seconds until
the hour display starts flashing
3. rotate the white knurled ring to set the hours
4. briefly press the
button; the minute display
starts flashing
5. rotate the white knurled ring to set the minutes
6. briefly press the
button to save the time
alarm times:
1. unlock the buttons by sliding the
switch to
the left
2. press and hold the
button for 2 seconds
until alarm time
1
starts flashing
3. rotate the white knurled ring to set the alarm
time for the first medication of the day; the
alarm time is set in increments of half an hour
4. briefly press the
button; alarm time
2
starts flashing
5. repeat instructions 3 and 4 for alarm times
2
,
3
,
4
and
5
(*)
6. briefly press the
button to save the alarm
times
*: If less than 5 alarm times are required, continue
rotating the ring until -:-- appears in the display; this
alarm time is now disabled
to change the alarm times:
1. unlock the buttons by sliding the
switch to
the left
2. press and hold the
button for 2 seconds
until alarm time
1
starts flashing
3. repeatedly press the
button until the alarm
time you’d like to change starts flashing
4. rotate the white knurled ring to set the new
alarm time (*)
5. repeatedly press the
button to save the new
alarm time(s)
*: If you want to delete an alarm time completely,
continue rotating the ring until the display shows
-:--; this alarm time is now disabled
ACP-80
Electronic pill box with alarm.
Introduction:
The Alecto ACP-80 pill box allows you to store
medicine for 5 daily moments. You can program up
to 5 times at which the alarm must sound while the
display indicates which medicine must be taken.
This schedule is repeated daily until you program
different times.
The ACP-80 pill compartments are only suitable for
dry medicine (pills, capsules, etc.), not for liquid or
ointments.
Power supply:
The ACP-80 is powered by 2 batteries: One
CR2025 lithium button cell for the clock and timer
function. This battery is already installed by the
factory, but can only be used after removing the
insulating strip.
The other is a 1.5V battery (size AAA) for the
sound and vibration alarm and for the display light-
ing. This battery is not included. Please use an
alkaline battery for this, not a rechargeable one.
1
2
3
1
2
4
