210cc 4 stroke Petrol High Pressure Washer
AFTER SALES SUPPORT
(toll free)
MODEL No.: SHW196 • 06/2019 9885
e-mail: [email protected]
AUS
29
1300 889 028
AUS
WARNING! Do not operate the machine in closed or poorly
ventilated areas as the exhaust gas contains poisonous
substances. Keep hands, feet, hair and clothing away from all
the moving parts of the machine. The exhaust and other parts
of the machine will become hot during use.
WARNING: While in operation, the muffler (8) will be very
hot, avoid any person or pet approaching it. Any obstacle
must be away from the muffler at least 80cm.
NOTE: To start the engine, make sure that the spark plug cap
is located on the spark plug (26). The machine is filled with
sufficient SAE 10W-30 4 Stroke engine oil and fresh unleaded
fuel, and both the oil/fuel should be added following the steps
described in Adding fuel and Connecting a water supply to the
pump (47).
Start the engine (see fig. N1-N5)
IMPORTANT: Below steps described are very important,
read them carefully!
Electric start (see fig. N1-N5)
1) Before starting, install the lead-acid battery in the battery
compartment (10). See Installing the Lead-acid battery.
2) Pay attention to the symbols on the back machine near the choke
lever (28) and throttle lever (30).
3) To start the engine, follow the steps according to the two conditions
shown below:
a)
Cold engine state:
The washer is not used up for more than 1 hour.
Under this condition, move the choke lever (28) to the left. Be sure
to move it to the end.
b)
Warm engine state:
The engine has shut down for a short period
of time. Under this condition, move the choke lever (28) to the right.
Be sure to move it to the end.
Operation
Summary of Contents for Workzone titanium SHW196
Page 54: ...This page is blank ...
Page 55: ...This page is blank ...
