VersAlarm
™
I/O
Indoor/Outdoor Alarm Panel | Model: VLIO-0001
Safety Guidelines
Step 2: Installing Conduit / Fittings
Before proceeding with the installation or operation of this product,
read all instructions thoroughly, as well as complying with all federal,
state and local codes, regulations, and practices. This product must
be installed by qualified personnel familiar with all applicable local
electrical and mechanical codes. Refer to the National Electrical Code
(NFPA 70). Failure to properly install and test this product can result in
personal injury or equipment malfunction.
WARNING
Step 1: Remove Bottom Cover
Q
SG
00
00
1_
Re
v0
4_
VL
IO
-0
00
1_
Ve
rs
Al
ar
m I
O | S
ep
te
m
be
r 1
9, 2
02
2 1
0:
41 A
M
Remove the bottom enclosure cover screw, slide directly downward
(1A) and then pull directly away (1B).
Using the pre-marked center hole
locations (2A), mark and drill out
on the bottom of the enclosure.
The size(s) will depend on desired
conduit fitting (maximum 0.75″).
Place the conduit fitting (2B) in
the drilled out hole and make sure
it’s secured. Then, install conduit
(2C) into the fitting.
Note: Seal all conduits to prevent moisture and
gases from entering the enclosure per local codes.
CAUTION:
Nonmetallic enclosure does not provide
proper grounding between conduit connections. Use
grounding bushings and jumper wires.
Step 3: Mount Enclosure
Determine the mounting location
for the VersAlarm™ I/O. Hold the
alarm up to the desired mounting
location, mark the drill hole
locations. Once marked, drill pilot
holes for screws (not included)
and use wall mount anchors (not
included) if necessary. Place
enclosure in mounting location,
adjust until the pilot holes are
lined up with the enclosure and
fasten screws to secure the alarm
panel in place.
QUICK START GUIDE
2A
2B
2C
1A
1B
Step 4: Wiring
The diagram below shows the six terminals on the terminal block that
consists of three pairs of connections.
1) Install the sensor to terminals 1 and 2.
2) Installing an auxiliary device to terminals 3 and 4 is optional.
3) Install incoming power to terminals 5 and 6, line (L1) in terminal 5
and neutral (N) in terminal 6.
4) NEVER leave ground wire exposed inside the panel, use provided
Wago connector for wire termination.
Installing Wire into Wago Connector:
1) Lift tab(s) upward.
2) Insert wire(s) into slot.
3) Press tab(s) downward.
4) Make sure wire(s) are secured.
POWER
SENSOR
AUX
1
2
3
4
5
6
TO OPEN
WAGO
TO CLOSE
WAGO