GNI Modules
Network Interface (NI) Modules
page 5-14
OmniSwitch 8800 Hardware Users Guide
December 2004
Installing MiniGBIC Connectors
If you are installing an OS8-GNI-U8 or OS8-GNI-U24 module, you must install Miniature Gigabit Inter-
face Converters (MiniGBICs) as required. OS8-GNI-U8 modules provide ports for up to 8 MiniGBICs and
OS8-GNI-U24 modules provide ports for up to 24 MiniGBICs. These MiniGBIC are packaged separately.
To install a MiniGBIC follow the steps below.
Anti-Static Warning.
Before handling any components, free yourself of static by wearing a grounding
strap, or by grounding yourself properly. Static discharge can damage the MiniGBIC, as well as the switch
and uplink module. Refer to
“Using the Grounding Wrist Strap and Chassis Grounding Lug” on page 5-29
for more information.
1
When inserting a MiniGBIC, be sure that the hinged face is closed.
2
Slide the MiniGBIC straight into the slot until the module clicks firmly into place.
3
Push the MiniGBIC into the slot until it clicks into place.
Note.
The diagram below is a representation only; the physical appearance of the actual MiniGBIC may
vary.
Caution.
The MiniGBIC should slide in easily. Do not force it into the slot. If any resistance is encoun-
tered, ensure the MiniGBIC is aligned properly. Forcing the MiniGBIC into the slot can damage the unit,
as well as components on your GNI module.
Note.
To remove a MiniGBIC, you must first open the MiniGBIC’s hinged face to approximately ninety
degrees. Then, grasp the hinged face and carefully pull the MiniGBIC straight out of the slot.
LIN
K
A C
T
LINK
A C
T
LINK
A C
T
LINK
A C
T
8
7
6
MiniGBIC Module
MiniGBIC Slot
GNI Module
