Installing and Managing Power over Ethernet (PoE)
Power over Ethernet Components
OmniSwitch 7700/7800 Hardware Users Guide
April 2005
page 3-7
OS7-IPS-600A PoE Power Supply
OS7-IPS-600A PoE Power Supply Front Panel
OS7-IPS-600A Power Supply Technical Specifications
Power
600 watts
Input Voltage
85–270 VAC
Frequency
47–63 Hz
Input Power
800 watts, maximum
AC OK
DC
OVER
TEMP
OK
CAUTION
: THIS UNIT MAY BE EQUIPPED
WITH MULTIPLE POWER SUPPLY CORDS.
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DISCONNECT ALL POWER SUPPLY
CORDS BEFORE SERVICING UNIT.
ATTENTION
: CET APPAREIL PEUT
COMPORTER PLUS D'UN CORDON
D'ALIMENTATION. AFIN DE PREVENIR LES
CHOCS ELECTRIQUES, DEBRANCHEZ TOUS
LES CORDONS
D'ALIMENTATION
AVANT DE FAIRE
LA REPARATION.
!
AC OK (Top LED).
Displays solid green when
the power supply’s AC cur-
rent status is OK and the
power supply is operating.
Off when the power supply
is not operating.
DC OK (Middle LED).
Displays solid green when
the power supply’s DC cur-
rent status is OK and the
power supply is operating.
Off when the power supply
is not operating.
OVER TEMP (Bottom
LED).
Off when the power
supply is operating under
supported temperature con-
ditions.
Displays solid amber when a
temperature error is detected
in the power supply hous-
ing. If a temperature error is
detected, check for an air-
flow obstruction at the air
intake vent or at the back of
the chassis. If no airflow
obstruction exists, remove or
replace the power supply
immediately. Refer to the
sections below for important
information on replacing
power supplies and power
supply redundancy.
Power Switch.
indicates
on
position;
indicates
off
position.
Power
Supply
LEDs
Power Connector Socket.
Type IEC-320-C13. Supports
one 10 amp power cord.
It is recommended that you use
Alcatel-provided power cords.
Air Intake Vent.
The air
intake vent provides cooling
and temperature control for the
power supply. Maintain a front
clearance of at least six inches
to ensure proper airflow.
