Chassis Management Module (CMM)
CMM Front Panel
OmniSwitch 7700/7800 Hardware Users Guide
April 2005
page 4-7
8
You can also save your changes in real time to the switch’s running memory by entering
commit
system
at the boot prompt:
Boot > commit system
Caution.
There are two important things to consider when using the
commit system
command to save
serial connection changes:
•
Output to the terminal may become illegible due to incompatible serial connection settings between the
switch and the terminal emulation software.
•
If you use the
commit system
command only, changes will
not
be saved to the switch’s
boot.params
file and will be lost if the switch is rebooted. To save changes to the
boot.params
file, refer to step 7.
9
Return to the CLI prompt by entering
exit
at the boot prompt.
Configuring X-ON/X-OFF Protocol
By default, X-ON/X-OFF protocol is enabled on the console port. To enable and disable the X-ON/X-OFF
protocol on a console port that you are logged into use the
command by entering
session
xon-xoff
followed by either
enable
or
disable
.
For example, to disable X-ON/X-OFF on a console port enter:
-> session xon-xoff disable
Note.
To enable or disable the X-ON/X-OFF protocol on the secondary CMM you must log into the
secondary CMM and then execute the
session xon-xoff
command.
