Alcatel Alcatel OmniAccess 4324, Installation Manual

Page: 26 / 44

OmniAccess 4324: Installation Guide
12 Part 031640-00 May 2005
Connecting Power
Verify you understand the procedure and all precautions.
Before beginning, read the entire procedure. Verify you understand all the
precautions in these steps as well as those on
page 6 .
Verify that your site’s electrical system is compatible with the
switch.
The switch power input is auto-ranging and accepts 90~132/180~264 VAC, 50
to 60 Hz, 4.0/2.0 A.
N
OTE
— Use of a power line conditioner or Uninterruptible Power Supply (UPS)
can decrease or mitigate problems caused by power service fluctuations. Ver-
ify that the output of any power shaping device is compatible with the Alcatel
Wireless LAN Switch power supplies.
Verify that the switch power supply can handle the POE devices.
The total power drawn by all connected Power Over Ethernet (POE) devices
must not exceed 200 W total. For details, see
“POE Power Requirements” on
page 15 .
Attach the power cord to the power input socket at the back of
the switch.
Plug an appropriate power cord into the power input socket. Use the included
power cord if it is compatible with your electrical outlet. Otherwise, replace the
power cord with the type appropriate for your country. The power input socket
accepts a power cord with a standard IEC320 connector.
Attach the power cord to a proper electrical outlet.
Once power is connected, the switch will automatically turn on and you can
perform the power-on test (see
page 13 ).
C
AUTION
— This procedure should be performed by a trained technician.
C
AUTION
— For proper safety and performance, the power cord must be
rated to 10 A and conform to grounded electrical standards in the
country where the product is operated.
1
2
3
4
5