Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 976 / 2018

LINK OAM Commands
page 26-8 OmniSwitch 6250 CLI Reference Guide November 2009
efm-oam port keepalive-interval
Configures the timeout interval for the dynamically learned neighboring devices on a port or on a range of
ports. Keepalive-interval is the maximum time period for which a LINK OAM port shall wait for a hello
message from its peer before resetting a discovery session.
efm-oam port slot/port[-port2] keepalive-interval seconds
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
-port2 Specifies the last port in the range of ports.
seconds Specifies the keep-alive interval value in seconds. The range for this
interval is 5 to 120 seconds.
Defaults
By default, the keep-alive interval value is 5 seconds.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Even if unsupported OAMPDU is received on the port, keep-alive timer is reset on the port.
•
To set the timer to its default value, set 5 seconds as the keepalive-interval.
Examples
-> efm-oam port 1/1 keepalive-interval 10
-> efm-oam port 2/1-10 keepalive-interval 10
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaDot3OamTable
alaDot3OamKeepAliveInterval
efm-oam port hello-interval Configures the time interval (in seconds) by which the information
OAMPDUs are transmitted out of a LINK OAM enabled port.
show efm-oam port detail Displays the configuration and other related parameters for a port.