Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 921 / 2018

Ethernet OAM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 25-9
ethoam association mhf
Modifies the MIP Half Function
(
MHF) value of an Ethernet OAM Maintenance Association.
ethoam association association_name domain {domain_name | mac_address} mhf {none | explicit |
default}
Syntax Definitions
association_name Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
domain_name Specifies the domain name. For more information on the different
formats of the domain name, refer to
ethoam domain command on
page 25-3 .
mac_address Specifies the CFM system MAC address.
none Specifies that no MHFs can be created for the specified VLAN ID.
explicit Specifies that MHFs can be created for the specified VLAN ID only on
Bridge ports through which this VLAN ID can pass and only if a Main-
tenance End Point (MEP) is created at a lower MA level.
default Specifies that MHFs can be created on the specified VLAN ID on any
Bridge port through which this VLAN ID can pass.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The association_name should be unique amid all those used by or available to the service provider within
a domain.
Examples
-> ethoam association alcatel-sales domain esd.alcatel-lucent.com mhf none
Release History
Release 6.6.1; command was introduced.
parameter default
none | explicit | default none