Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 878 / 2018

VLAN Stacking Commands
page 24-16 OmniSwitch CLI Reference Guide November 2009
ethernet-service sap cvlan
Associates customer VLAN (CVLAN) traffic with a VLAN Stacking Service Acces Point (SAP). The
parameter values configured with this command are applied to frames received on all SAP UNI ports and
determines the type of customer traffic that is accepted on the UNI ports and processed by the service.
ethernet-service sap {sapid} cvlan {all | cvid | cvid1-cvid2 | untagged}
ethernet-service sap {sapid} no cvlan {all | cvid | cvid1-cvid2 | untagged}
Syntax Definitions
sapid The SAP ID number (2–4094).
all Applies the SAP profile to tagged and untagged frames.
cvid1 Applies the SAP profile to frames tagged with this CVLAN ID.
cvid1-cvid2 Applies the SAP profile to frames tagged with a CVLAN ID that falls
within this range of CVLAN IDs (for example, 10-12 specifies frames
tagged with CVLAN 10, 11, or 12).
untagged Applies the SAP profile only to untagged frames.
Defaults
By default, no CVLAN traffic is associated with the SAP ID when the SAP is created.
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
Use the no form of this command to remove a CVLAN ID or the designation for all or untagged
frames from the SAP. Note that when the last CVLAN parameter is deleted from an SAP configura-
tion, the SAP itself is not automatically deleted.
•
The all and untagged parameters are configurable in combination with a CVLAN ID. For example, if
untagged and a CVLAN ID are associated with the same SAP ID, then the SAP profile is applied to
only untagged traffic and traffic tagged with the specified CVLAN ID. All other traffic is dropped.
•
The SAP ID specified with this command must already exist. Use the ethernet-service sap command
to create a SAP.
•
Note that this command is not supported with SAP IDs that are associated with an IPMVLAN.
•
Configuring both the all and untagged parameter for the same SAP is not allowed. Specify only one of
these two parameters per SAP.
•
When either the all or untagged parameter is configured for the SAP, the default VLAN for the UNI
ports associated with the SAP is changed to the VLAN assigned to the service that is associated with
the SAP.